J0901 Step 3. Construct Drip Irrigation

j0901_micro_irrigation_3  Button-Previous-icon  Action-button-home-icon  Button-Next-icon




Cut the lower part of the plastic bottle
Make a hole in the plastic bottle cap
Put some glue on the tube and the bottle cap hole
Allow the glue to dry

Making The Drip Irrigation Drip irrigation is made by assembling the materials according the following steps:
1 Cut the lower part of the plastic bottle but keep it a little attached to the upper part so it can be used as a flap/cover. The purpose of using a flap is to keep away leaves and dirt like dust or rocks which can block the hole in the drip irrigation bottle.
2 Make a hole in the plastic bottle cap using a sharp nail. Make sure the the size of the nail is in accordance with the size of the pipe or the small-sized water tube.
3 Insert plastic tube into the bottle cap through the hole made in the previous step.
4 Put some glue on the tube and the bottle cap hole in order to keep the tube from falling off the bottle cap. Try to insert the tube 5-centimetre deep into the bottle, then leave it for about 15 minutes to allow the glue to dry

Leave a Reply

This site uses Akismet to reduce spam. Learn how your comment data is processed.